Trend

Replacement constant speed control maget for the T8 router.

A range of thin kerf tungsten carbide tipped blades for wood and wood-based materials. For use in cordless circular, plunge and table saws, and ava...

Trend Professional 1/4in shank bearing guided trimming cutter - 12.7mm diameter for laminate and template work 12.7mm diameter X 32mm cutting depth...

Replacement Pinion Wheel for Stepper Motors - 1.5 12T 17FWSuitable for X and Y Stepper Motors on all SmartBench Variants.

A complete cutter set for producing matchlining. Jointing parts are interchanged on the arbor to change the mode of the cutter. Set Ref. C255 can b...

A range of thin kerf tungsten carbide tipped blades for cross-cutting wood and wood-based materials using cordless Mitre saws. Ideal for timber ski...

Self-guiding cutters with the facility to change the profile by fitting a larger bearing & varying the depth. Supplied with two bearings. T...

These slotters have a M12 threaded boss to enable them to be threaded onto the arbor without the need for a securing nut.

Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood ...

Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood ...

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TC...

Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with.The guide bearing follows the vertical edge or template. ...

These slotters have a 12mm clear bore to enable them to be mounted at any position on the arbor in combination with spacers, with or without a bear...

Replacement inner plate for T9, T11 and T14 routers

Replacement headcover and face seal for the AIR/PRO.

This set incorporates two drill countersinks and matching plug cutters. Plugs cutters are made from Tool Steel and are very slightly tapered. Use o...

These cove style cutters with two flutes, give radiused grooves for decorative panel finishes and board edges. For deep channels, take a series of...

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TC...

Replacement insert ring 68mm ID for CRT/MK3.

Use drill next to walls. Drill and fixes in tight spaces. Outer sleeve rotates allowing secure positioning. Shaft swivels to 15 degree angle....

High-quality, hook & loop nylon pad saver. Extends the life of the sander backing pad by providing a sacrificial barrier between the sander and...

Shank mounted bearing profilers are ideal for template guidance. Use for rebating and trimming edges only. Extra care must be taken to avoid cu...

Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with.The guide bearing follows the vertical edge or template. ...

Replacement Bottom Plate Calibration Frame for T18S/CS165